DABPRESS 30mm Hammer Styled Pollen Press (Flower & Hash) - With 2x4" Filters, Loading 7g Materials
DABPRESS 30mm SS Hammer Styled Pollen Press ( Flower & Hash ) - Works with 2x4" Filters, Loading 7g Materials
- Hash & Flower - The cylinder pre-press mold is well suited to compress flowers, hash, etc.
- 0.15mm Gap - Small gap cylinder prepress mold also works great with kief, hash, and flowers.
- Hammer Styled Mold - After loading the material and insert the hammer nail, and strike it with a rubber mallet!
- PVC Sheet Included - Easy to insert pucks into filter bags with PVC sheet attached.
-
Save Rosin Filter - Double squashes by cutting 2x4.5" rosin bags into half for flower if pairing it with cylinder mold.
- Item No.: dp-pm30h
- Material: 304 Stainless Steel
- Inner Diameter: 1.18 inch (30mm)
- Outer Diameter: 1.46"
- Height: 3.38"
How to Avoid Filter Bags from Blowing out?
- Remove excess stems from flowers.
- Use less material in your filter bag.
- Preheating your material first to get it melty before you begin to apply pressure.
- Apply the pressure more slowly.
Troubleshooting Collection:
In order to provide rosineer with the best experience, we collected the past complaints in the list; I would also consider it will be helpful for you. We also especially look forward to you sharing your suggestions and comments, and the issues you have encountered to us via support@dabrpess.com (updating).
- My Rosin Press Hydraulic Hand Pump Will Not Maintain Pressure Well, Why?
- Rosin Press Delivered the Inaccurate Temperature After Measuring with My Infrared (IR) Thermometer Gun
- My Bottle Jack Rosin Press Does Not Hold Pressure, Why?
- Why Can't We Use Rosin Press to Produce the Puck of Flower or Hash?
- Piston Rod of Hydraulic Cylinder Rosin Press Can Lift But It Can Not Move Back
- I Would Like to Upgrade Dabpress Rosin Press, Is This possible and Which Parts Would I Need?
- How to Replace the Bottle Jack?
- About 2x4" Rosin Pre Press Mold, Why Is the inside of the Mold Not 2x4"?
- How to Replace PID module?
- My Temp Controller Box Caused the Issue After Changing the Parameters, How to Fix It?