2x4 Pre Press Mold ( Flower & Hash ) - Loading 7 to 12g Materials - Pairs 2x4 Inches Filter Bags
- Double PETP Sheet Attached - Create 7 - 14g slim pucks with included non-stick PETP plates.
- Rectangle Pucks Created - 2x4" pre-press puck maker pairs with 2x4" or 2x4.5" filter bags( 2x4.5" bag could be cut into 2x4" bag ).
- Anodized Aluminum Made - The mold is anodized into a silver color for getting a smooth surface.
- Tools To Assist - Recommend to create pucks with an arbor press or bar clamp to compress; Do not make pucks with other rosin press to protect the working surface from scratching.
- Hash & Flower - The mold well suited to create pucks of hash and flower
- Item No.: dp-pm4007s
- Anodized Aluminum Made
- The Puck Size: 40 mm (W) x 7 mm ( T) x 85 mm ( L)
- The Puck Size: 1.57" x 0.27" x 3.34"
- 2x4" Rectangle Puck Maker
How to Avoid Filter Bags from Blowing out?
- Remove excess stems from flowers.
- Use less material in your filter bag.
- Preheating your material first to get it melty before you begin to apply pressure.
- Apply the pressure more slowly.
- How to start
- Recommendations on materials loaded.
- Rosin filter bags suggested.
- The yields are not very good, why?
- How to apply the pressure for optimal yield and quality?
- How to begin extracting.
- Important notice.
- Troubleshooting.
- Question and answer.
- Check it out here (Highly recommended to read it before doing purchase)
User Manual & Troubleshooting Includes:
QUESTIONS & ANSWERS
Ask a Question-
How does it heat?
dp-pm4007s is just a puck maker.
-
The pre mold cylinder says no shake, would this be better for shake?
It works great with the shake! Thanks for your reminding.
-
Does this work with the hydraulic presses that you sell?
For sure! The mold will create a rectangle puck to be paired with 2x4" rosin bags. Please notice, don't press the buds with rosin press, it will scratch the surface. Irwin Clamp was recommended.
-
Are you planning on manufacturing any more of these?
For sure, it will be available after two weeks on eBay.com (At the end of Oct,2018)