0 comments / Posted on by Dabpress Team

What is a PID temperature controller?

The controller would then send a signal to increase the applied heat to raise the temperature back to the setpoint. However, once the temperature reaches setpoint, the heater will again kick in. Unlike ON/OFF control, PID control determines the exact output value required to maintain the desired temperature. 

Digital PID temp controller needs an initial calibration period.

The PID controller needs a calibration process to adapt to rosin plates. After several runs, we will obtain a more accurate temperature. 

When will we calibrate PID temp controller?

If the temp controller works great, you do not need to calibrate.  Only when ambient temperature changes a lot we would suggest to calibrate.  The video below will show a demonstration on how to recalibrate. Please notice, it doesn't help a lot.

So we suggest you don't reset unless you have to. 

How to calibrate your PID temp controller?

1, Press for over three seconds with "SET" button.

    Display: “AL1/003”

2, Press "SET" button two times

    Display: “AEU/0000”

3, Press Up arrow then you get “0001”

4, Press for over three seconds to exit 

Well done!

Watch the Video Now!


Related Posts

How To Get the Affordable Hydraulic Pump With A Pressure Gauge For dp-hr10t35v Driptech Rosin Press?
How To Get the Affordable Hydraulic Pump With A Pressure Gauge For dp-hr10t35v Driptech Rosin Press?Trying to get a j...
Read More
Kief, Dry Sift, Trim, Bubble Hash Rosin Press
Kief | Dry Sift | Trim | Bubble Hash - Rosin Press Kief Rosin Press Dry Sift Rosin Press  Bubble Hash Rosin Press  ...
Read More
Rosin Press Plates - All Features of Dabpress Plates
Rosin Press Plates - All Features of Dabpress Plates  Caged Plates | Dabpress dp-rp37 Move onto Hydraulic Press, Pl...
Read More

0 comments

Leave a comment

All blog comments are checked prior to publishing